Complete Package - $32,000 w documentation
1993 IMSA GTO Championship
1998 SCCA SARRC GT-1 Championship
2001 Rolex 24 Hours At Daytona - AGT 4th Place Finish
2005 SCCA SARRC GT-1 Championship
This car is competitive in SCCA GT-1, easy to setup and also eligible for the Historic Sportscar Racing (HSR) series. It has a great history and is well documented. The car also appeared in the Earnhardt Corvette racing commercial.
Complete information & pictures on our website: http://www.tropiczoneracing.com/Olds-For-Sale.htm
Car Specifications
Chassis: Riggins Engineering Tubeframe
Body: Oldsmobile Cutlass Supreme
Wing: Approved ACP wing & blade spoilers
Wheelbase: 102.5 inches
Weight: 2,480 pounds
Steering: Appleton power steering
Wheels: 16" x 12" aluminum
Brakes: Front - AP Rear - Wilwood
Custom Coleman full floating disks
Shocks: Penske
Motor: Lozano Bros. Chevy small block, Displacement: 310 ci
Horsepower: 600
Carburetor: 850 Holley
Heads: 18 degrees, siamese port
Jesel valvetrain system
Cooling: Oil/water heat exchanger
Separate diff & trans coolers w fans
Oil System: 4 stage dry sump
Transmission: 4 speed Jerico
Clutch: 5.5" Quartermaster - triple disk
Rear-end: Stock Car Products quick change
Ignition: Dual ignition systems
Fuel: Primary & reserve pumps
Fire System: 10 lb. halon (new 2005)
Driver: Cool suit system
Spares
All - Original Riggins body molds
1 - Nose box, complete
1 - Nose box, needs repair
1 pair - Replacement tail lights (like new)
1 - 9" Ford axle setup
1 - Detroit locker for quick change
9 - Quick change gear sets
2 - Drive shafts
2 - Axles for quick change & 2 for the Ford 9"
4 sets - 16" wheels (plus 2 extra)
1 set - 17" wheels (IMSA)
1 - Differential pump
1 - Differential cooler fan
1 - New radiator
1 - New power steering pump
1 set - New upper & lower "A" arms
1 set - New steering arms
1 pair - New uprights
1 - Front sway bar
2 - Drive hubs (Stock Car Products)
2 - Front hubs (Stock Car Products)
2 - 5" Flowmaster mufflers
3 sets - Coil over springs
1 - 5 gallon aluminum fuel dump can with red head
1 set - Red head males for fuel rig
1 set - Brackets for air jacks - not installed
New brake and clutch lines
Lead ballast for car weight
Miscellaneous filters, belts, cables, etc.
Various used parts acceptable for "at track" spares
Master cylinder - brake, clutch
Rear calipers
16" brake disks ( 1 good set fronts for 17" wheels)
5.5" clutch & clutch plates
1 good throw-out bearing assembly
located 2 hours NW of Daytona Beach, FL, USA
Dave Bacher
phone: 904-282-0256
email: dbacher@tropiczoneracing.com
fax: 904-291-7955